olzlinks.blogg.se - Isuzu 6Wa1 Engine Manual

If more than 7 minutes have elapsed, remove the liquid gaskets, and re-apply them.

Assemble the parts within 7 minutes after applying the liquid gaskets.

When using liquid gaskets, remove all the old ones, wash the parts where they were used to remove any oil, grease, moisture and contamination, and then apply the designated liquid gaskets and assemble the parts.

Whenever the gaskets, oil seals, O-rings and other such parts are disassembled, be absolutely sure to replace them with new parts.

When re-mounting the parts, mount the same parts in the same positions where they were prior to disassembly.

When the valve train parts, pistons, piston rings, connecting rods, connecting rod bearings and crankshaft journal bearings have been disassembled, arrange them in sequence and store them.

Apply plenty of engine oil to the sliding surfaces in order to protect and lubricate the sliding surfaces during the initial operation.

When power needs to be supplied to the engine during inspections or other such jobs, exercise care since short-circuiting may occur.

When conducting maintenance work on the engine body, be absolutely sure to disconnect the battery grounding cable.

If foreign matter is allowed to enter, the cylinders and other parts may be seriously damaged when the engine is run. When the intake system has been removed, cover the air intake to prevent foreign matter from entering the cylinders.When lowering the engine, use an engine pallet, wood frame or other such means to support it at the engine foot and flywheel housing. When raising or supporting the engine, do not allow the jacks to come into contact with the oil pan.Observe the following precautions when conducting engine maintenance in order to both safeguard against engine damage and maintain the reliability of the engine performance. Precautions for jobs inherent to this engine 1B-16 Symptom: The engine does not turn over properly. 1B-14 Symptom: Lots of white smoke is emitted.

1B-12 Symptom: The engine turns over but fails to start 1B13 Symptom: Lots of black smoke is emitted. 1B-11 Symptom: The engine fails to turn over. 1B-3 Description of Functions and Operation. THIS MANUAL INCLUDES THE FOLLOWING SECTIONS: SECTION No.ĮNGINE Engine Mechanical (6WF1-TC) TABLE OF CONTENTS 6WF1-TC Engine. All rights are reserved to make changes at any time without prior notice.Īpplicable Model: C&E Series This Manual is applicable to 2006 year model and later vehicles. NOTICE Before using this Workshop Manual to assist you in performing vehicle service and maintenance operations, it is recommended that you carefully read and thoroughly understand the information contained in Section-0 under the headings “GENERAL REPAIR INSTRUCTIONS”.Īll material contained in this Manual is based on latest product information available at the time of publication. ENGINE (6WF1-TC (Common Rail) model) SECTION 1